Materiales didácticos interactivos en Ingeniería de Fabricación
- Autores: Pedro M. Hernández Castellano, María Dolores Marrero Alemán, Fernando Ortega, Rubén Paz, Pedro Socorro, Luis Suárez, Antonio Benítez, Sandra Taboada, Eduardo Taboada, Illari Antón, Juan Rodríguez, Claudio Hernández, Pablo Rubén Bordón Pérez
- Localización: II Jornadas Iberoamericanas de Innovación Educativa en ámbito de las TIC: Las Palmas de Gran Canaria, 12 y 13 de noviembre de 2015 / Jesús Bernardino Alonso Hernández (ed. lit.), David Sánchez Rodríguez (ed. lit.), Carlos Manuel Travieso González (ed. lit.), 2015, ISBN 978-84-608-3145-7, págs. 23-28
- Idioma: español
- Enlaces
-
Resumen
This work is part of a methodological renovation project from Ingeniería de Fabricación Innovative Education Group, from University of Las Palmas de Gran Canaria. It has developed learning materials for courses in Manufacturing Engineering that can be used in several degrees. The first learning material, it was decided to take a plastic injection mould as a teaching resource. Abundant information generated has been used to develop an interactive electronic publication. This learning material has been chosen by the Publishing and Scientific Diffusion Service from this University, as a new line of work in publications of educational innovation. The group is developing more training materials on other manufacturing processes as well as cross-contents dimensional tolerances in the ISO GPS system. All this work has generated a lot of educational resources for both laboratory practices and interactive multimedia documents.
