Resumen de A new index for detecting and avoiding type ii singularities for the control of non-redundant parallel robots
Parallel Robots (PR)s are mechanisms where the end-effector is linked to the base by at least two open kinematics chains. The PRs offer a high payload and high accuracy, making them suitable for various applications, including human robot interaction. However, in proximity to a Type II singularity (singularity within the workspace), a PR loses control over the movements of the end-effector. The loss of control represents a major risk for users, especially in robotic rehabilitation. In the last decades, PRs have become popular in lower limb rehabilitation because of the increment in the number of people living with physical limitations. Thus, this thesis is about the detection and avoidance of Type II singularities to ensure complete control of a non-redundant PR for knee rehabilitation and diagnosis named 3UPS+RPU.
In the literature, several indices exist to detect and measure the closeness to a singular configuration based on analytical and geometrical methods. However, some of these indices have no physical meaning, and they are unable to identify the actuators responsible for the loss of control. This thesis contributes two novel indices to detect and measure the proximity to a Type II singularity capable of identifying the pair of actuators responsible for the singularity. The two indices are the angles between the linear (T_i,j) and the angular (O_i,j) components of two i,j normalised Output Twist Screws (OTSs). A Type II singularity is detected when the angles T_i,j = O_i,j = 0 and its closeness is measured by the minimum T_i,j (minT) and minimum O_i,j (minO) for planar and spatial cases, respectively. The effectiveness of the indices T_i,j and O_i,j is evaluated from a theoretical and experimental perspective in a 3UPS+RPU and a five bars mechanism. Moreover, an experimental procedure is proposed for setting a proper limit of closeness to a Type II singularity by the progressive approach of the PR to singular configuration and measuring the last controllable pose.
Subsequently, two novel deterministic algorithms for releasing and avoiding Type II singularities based on minT and minO are developed for non-redundant PRs. The minT and minO are used to identify the two actuators to move for release or prevent the PR from the singularity. Both algorithms require an accurate measuring of the pose reached by the end-effector. The algorithm to release a PR from a singular configuration is successfully applied in a vision-based hybrid controller for the 3UPS+RPU PR. The controller uses a photogrammetry system to measure the pose of the robot due to the degeneration of the kinematic model in the vicinity of a singularity. The Type II singularity avoidance algorithm is applied to offline and online free-singularity trajectory planning for a five-bar mechanism and the 3UPS+RPU PR. These applications verify the low computation cost and the minimum deviation introduced in the original trajectory for both novel algorithms.
The direct implementation of a force/position controller in the 3UPS+RPU PR is unsafe because the patient could unintentionally drive the PR to a Type II singularity. Therefore, this thesis concludes by presenting a novel force/position controller complemented with the Type II singularity avoidance algorithm. The complemented controller is evaluated during patient-active exercises in a mannequin leg and an uninjured human limb. The results show that the novel combined controller keeps the 3UPS+RPU PR far from singular configurations with a minimum deviation on the original trajectory. Hence, this thesis enables the 3UPS+RPU PR for the safe rehabilitation of injured lower limbs.
