Periodo de publicación recogido
|
|
|
Optimization in thermal friction drilling for SUS 304 stainless steel.
W.-L. Ku, C.-L. Hung, S.-M. Lee, H.-M. Chow
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 53, Nº. 9-12, 2011, págs. 935-944
Optimization in MAF operations using Taguchi parameter design for AISI304 stainless steel.
L.-D. Yang, C.-T. Lin, H.-M. Chow
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 42, Nº. 5-6, 2009, págs. 595-605
Surface modification using semi-sintered electrodes on electrical discharge machining.
Y.-F. Chen, H.-M. Chow, Y.-C. Lin, C.-T. Lin
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 36, Nº. 5-6, 2008, págs. 490-500
Effects of finishing in abrasive fluid machining on microholes fabricated by EDM.
Y.-C. Lin, H.-M. Chow, B.-H. Yan, H.-J. Tzeng
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 33, Nº. 5-6, 2007, págs. 489-497
Finishing effect of abrasive flow machining on micro slit fabricated by wire-EDM.
H.-J. Tzeng, B.-H. Yan, R.-T. Hsu, H.-M. Chow
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 34, Nº. 7-8, 2007, págs. 649-656
Feasibility study of micro-slit EDM machining using pure water.
C.-T. Lin, H.-M. Chow, L.-D. Yang, Y.-F. Chen
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 34, Nº. 1-2, 2007, págs. 104-111
Study of magnetic abrasive finishing in free-form surface operations using the Taguchi method.
C.-T. Lin, L.-D. Yang, H.-M. Chow
International journal of advanced manufacturing technology, ISSN 0268-3768, Vol. 34, Nº. 1-2, 2007, págs. 122-130
Esta página recoge referencias bibliográficas de materiales disponibles en los fondos de las Bibliotecas que participan en Dialnet. En ningún caso se trata de una página que recoja la producción bibliográfica de un autor de manera exhaustiva. Nos gustaría que los datos aparecieran de la manera más correcta posible, de manera que si detecta algún error en la información que facilitamos, puede hacernos llegar su Sugerencia / Errata.
© 2001-2024 Fundación Dialnet · Todos los derechos reservados