Resumen de Validity and Reliability of Force-Time Characteristics Using a Portable Load Cell for the Isometric Midthigh Pull
Andrew W. Pichardo, Jono Neville, Farhan Tinwala, John B. Cronin, Scott R. Brown
Many practitioners use the isometric midthigh pull (IMTP) to assess maximal strength in a safe, time-effective manner. However, expensive, stationary force plates are not always practical in a large team setting. Therefore, the purpose of this study was to establish the validity and between-session reliability of peak force, rate of force development (RFD), and impulse during an IMTP using 2 experimental protocols: a traditional fixed bar with a force plate (BarFP) and a flexible chain measured with a force plate (ChainFP) and a load cell (ChainLC). After a familiarization session, 13 resistance-trained men performed 3 trials of the BarFP condition and 3 trials of the chain-based conditions. The identical procedures were replicated twice more, with a week between each testing session. The main findings were (a) no RFD or impulse measures were found to achieve acceptable reliability across all methodological approaches and testing occasions; (b) peak force was reliable across all methods, with coefficient of variation ranging from 4.6 to 8.3%, intraclass correlation coefficient ranging from 0.94 to 0.98, and the least variability associated with the ChainLC condition; and (c) the ChainFP method was found to significantly underrepresent peak force by 4.8% (p < 0.05), with no significant differences between the ChainLC and BarFP methods. Therefore, the ChainLC would seem a valid, reliable, portable, and cost-effective alternative to force plates when assessing maximal isometric strength in the IMTP.
