Catalytic oxidation of emissions in combustion systems for forest biomass, using catalysts with tio2 support

• CRISTIÁN CERDA ^[1] ; LEONARDO ROMERO ^[2] ; ROMEL JIMÉNEZ ^[3] ; GUSTAVO FUENTES ^[5] ; MIGUEL ANGEL CENTENO ^[4] ; NELSON ALARCÓN ^[1]
  1. [1] Universidad Católica de Temuco

     Universidad Católica de Temuco

     Temuco, Chile

     
  2. [2] Universidad Católica del Norte

     Universidad Católica del Norte

     Antofagasta, Chile

     
  3. [3] Universidad de Concepción

     Universidad de Concepción

     Comuna de Concepción, Chile

     
  4. [4] Universidad de Sevilla

     Universidad de Sevilla

     Sevilla, España

     
  5. [5] Universidad A. Metropolitana Área de Ingeniería Química

  Mostrar afiliaciones +
• Localización: Journal of the Chilean Chemical Society (Boletín de la Sociedad Chilena de Química), ISSN-e 0717-6309, ISSN 0366-1644, Vol. 51, Nº. 4, 2006, págs. 1015-1021
• Idioma: español
• Enlaces
  • Texto completo
• Resumen

  • A study was made of the catalytic oxidation of a model mixture of effluents from forest biomass combustion equipment, consisting principally of methane (CH4), naphthalene (C10H8), carbon monoxide (CO) and oxygen-poor air (10% O2, balance N2), in a laboratory reactor, using MeOx/TiO2 catalysts (Me = Fe, Cu or Mn), prepared using incipient wetness impregnation. It was observed that the addition of metal oxides to the TiO2 increases catalytic activity in the combustion of all the contaminants present in the model effluent (CH4, C10H8 and CO). The catalysts were characterised using the following techniques: SBET, XRD, DTG/DTA and TPD-NH3; and from these it was observed that the support presented only the anatase phase in all the catalysts, despite having been subjected to temperatures in excess of 1.000 K during combustion. The highest acidity among all the solids tested, measured by TPD-NH3, was obtained for the FeOx/TiO2 catalysts, which were also those which showed the greatest catalytic activity. This high level of activity may be related to the formation of isolated metallic phases; i.e. hematite (Fe2O3), which would be the active phase in the combustion of C10H8 and CH4. On the other hand, with to respect to the 5 % wt. values of Me/TiO2 (Me: Fe, Cu y Mn) catalysts, the CuO/TiO2 catalyst shows greater activity than Fe2O3/TiO2 and MnOx/TiO2 for the oxidation of CO, which would be related to the formation of CuO on the TiO2 surface. The formation of mixed phases between the metals and the TiO2 was not observed. The SBET of the most active catalyst, Fe2O3/TiO2 (where Fe is 5% w/w in value), was not subject to any changes during the reaction