Design advantages and analysis of a novel five-phase doubly-fed induction generator
-
Roland Ryndzionek [1] ; Michal Michna [1] ; Filip Kutt [1] ; Grzegorz Kostro [1] ; Krzysztof Blecharz [1]
-
[1] Gdańsk University of Technology
Gdańsk University of Technology
Gdańsk, Polonia
-
- Localización: Compel: International journal for computation and mathematics in electrical and electronic engineering, ISSN 0332-1649, Vol. 42, Nº 4, 2023, págs. 947-962
- Idioma: inglés
- Enlaces
-
Resumen
Purpose The purpose of this paper is to provide an analysis of the performance of a new five-phase doubly fed induction generator (DFIG).
Design/methodology/approach This paper presents the results of a research work related to five-phase DFIG framing, including the development of an analytical model, FEM analysis as well as the results of laboratory tests of the prototype. The proposed behavioral level analytical model is based on the winding function approach. The developed DFIG model was used at the design stage to simulate the generator’s no-load and load state. Then, the results of the FEM analysis were shown and compared with the results of laboratory tests of selected DFIG operating states.
Findings The paper provides the results of analytical and FEM simulation and measurement tests of the new five-phase dual-feed induction generator. The use of the MATLAB Simscape modeling language allows for easy and quick implementation of the model. Design assumptions and analytical model-based analysis have been verified using FEM analysis and measurements performed on the prototype. The results of the presented research validate the design process as well as show the five-phase winding design advantage over the three-phase solution regarding the control winding power quality.
Research limitations/implications The main disadvantage of the winding function approach-based model development is the simplification regarding omitting the tangential airgap flux density component. However, this fault only applies to large airgap machines and is insignificant in induction machines. The results of the DFIG analyses were limited to the basic operating states of the generator, i.e. the no-load state, the inductive and resistive load.
Practical implications The novel DFIG with five phase rotor control winding can operate as a regular three-phase machine in an electric power generation system and allows for improved control winding power quality of the proposed electrical energy generation system. This increase in power quality is due to the rotor control windings inverter-based PWM supply voltage, which operates with a wider per-phase supply voltage range than a three-phase system. This phenomenon was quantified using control winding current harmonic analysis.
Originality/value The paper provides the results of analytical and FEM simulation and measurement tests of the new five-phase dual-feed induction generator.
