Grinding of AISI 4340 steel whith interrupted cutting by aluminum oxide grinding wheel
- Autores: H. J. de Mello, D. Mello, E.C. Bianchi, P. Aguiar
- Localización: Proceedings of the VIII Iberian Conference on Tribology: Conference proceedings / Ana Eva Jiménez Ballesta (aut.), Tulia Espinosa Rodríguez (aut.), Noelia Saurín Serrano (aut.), Joaquín Arias Pardilla (aut.), María Dolores Bermúdez Olivares (aut.), 2015, ISBN 978-84-606-8904-1, págs. 87-94
- Idioma: inglés
- Enlaces
-
Resumen
There has been a great advance in the grinding process by the development of dressing, lubri-refrigeration and other methods. Nevertheless, all of these advances were gained only for continuous cutting; in other words, the ground workpiece profile remains unchanged. Hence, it becomes necessary to study grinding process using intermittent cutting (grooved workpiece – discontinuous cutting), as little or no knowledge and studies have been developed for this purpose, since there is nothing found in formal literature, except for grooved grinding wheels. In this paper, grinding trials were performed using a conventional aluminum oxide grinding wheel, testing samples made of AISI 4340 steel quenched and tempered with 2, 6, and 12 grooves. The cylindrical plunge grinding was performed by rotating the workpiece on the grinding wheel. This plunge movement was made at three different speeds. From the obtained results, it can be observed that roughness tended to increase for testing ...
