Two-dimensional hybrid model for magnetic field calculation in electrical machines: exact subdomain technique and magnetic equivalent circuit

• Brahim Ladghem Chikouche ^[1] ; Kamel Boughrara ^[2] ; Frédéric Dubas ^[3] ; Rachid Ibtiouen ^[2]
  1. [1] University of M'sila, Argelia; Ecole Nationale Polytechnique, Argelia
  2. [2] Ecole Nationale Polytechnique, Argelia
  3. [3] University Bourgogne Franche-Comté, Francia

  Mostrar afiliaciones +
• Localización: Compel: International journal for computation and mathematics in electrical and electronic engineering, ISSN 0332-1649, Vol. 40, Nº 3, 2021, págs. 535-560
• Idioma: inglés
• Enlaces
  • Texto completo
• Resumen

  • Purpose The purpose of this paper is to propose a two-dimensional (2-D) hybrid analytical model (HAM) in polar coordinates, combining a 2-D exact subdomain (SD) technique and magnetic equivalent circuit (MEC), for the magnetic field calculation in electrical machines at no-load and on-load conditions.

    Design/methodology/approach In this paper, the proposed technique is applied to dual-rotor permanent magnet (PM) synchronous machines. The magnetic field is computed by coupling an exact analytical model (AM), based on the formal resolution of Maxwell’s equations applied in subdomains, in regions at unitary relative permeability with a MEC, using a nodal-mesh formulation (i.e. Kirchhoff's current law), in ferromagnetic regions. The AM and MEC are connected in both directions (i.e. r- and theta-edges) of the (non-)periodicity direction (i.e. in the interface between teeth regions and all its adjacent regions as slots and/or air-gap). To provide accurate solutions, the current density distribution in slot regions is modeled by using Maxwell’s equations instead to MEC and characterized by an equivalent magnetomotive force (MMF) located in the slots, teeth and yoke.

    Findings It is found that whatever the iron core relative permeability, the developed HAM gives accurate results for both no-load and on-load conditions. Finite element analysis demonstrates the excellent results of the developed technique.

    Originality/value The main objective of this paper is to achieve a direct coupling between the AM and MEC in both directions (i.e. r- and theta-edges). The current density distribution is modeled by using Maxwell’s equations instead to MEC and characterized by an MMF.