Hybrid filter operation during nonlinear load current pulsations
-
Leszek Fracckowiak [1] ; Ryszard Strzelecki [1]
-
[1] Poznán University of Technology, Institute of Industrial Electrical Engineering, Polonia
-
- Localización: Compel: International journal for computation and mathematics in electrical and electronic engineering, ISSN 0332-1649, Vol. 16, Nº 1, 1997, págs. 38-48
- Idioma: inglés
- Enlaces
-
Resumen
Examines some basic aspects of hybrid filters, operating effectively when current pulsations of a non‐linear variable load occur. The operation of two hybrid filter systems, each equipped with an active power filter, working as: a) a controlled additional current source, b) a controlled additional voltage source, recognized by the authors in previous publications as the most advantageous solution has been examined. For both systems, vectorial equations in α,β co‐ordinates, describing their operation, have been presented. On the basis of these equations a common frequency model of three‐phase three‐wire hybrid filters has been elaborated. This model has been used for the evaluation of the filtration efficiency of line current harmonics, taking into consideration the applied methods and algorithms to separate filtered harmonics, above all at a pulsating load current. Some conclusions from the theoretical analysis have been verified by simulation of a line loaded by converter with an output current pulsating at frequencies 10 and 20Hz.
