Three-phase four-wire shunt active power filter working simultaneously as energy conditioner

• Andrzej Szromba ^[1]
  1. [1] Cracow University of Technology

     Cracow University of Technology

     Kraków, Polonia

     
• Localización: Compel: International journal for computation and mathematics in electrical and electronic engineering, ISSN 0332-1649, Vol. 36, Nº 3 (Special Issue: EPNC 2016), 2017, págs. 702-715
• Idioma: inglés
• Enlaces
  • Texto completo
• Resumen

  • Purpose – The purpose of this study is to find a control method for three-phase four-wire shunt active power filters, which uses a load-equivalent conductance for obtaining a reference signal for compensating non-active current.

    Design/methodology/approach – Changes of energy stored in an active filter’s reactance elements are monitored to find the active component of the load current. It is then used as a current reference to be realised as a supply source current. Computer simulation methods were used to verify the presented control method.

    Findings – To calculate the reference signal for the active filter action, it is enough to measure the active filter’s DC-side capacitors’ voltages. It has been proved that P regulators are sufficient to realise compensating current and to stabilise active filter capacitors’ voltages. The supply source-neutral conductor current can be zeroed even for nonlinear and unbalanced load-generating DC-component in its neutral conductor. In addition, the active filter can buffer load-active power changes and act simultaneously as a local energy accumulator.

    Originality/value – This paper provides an alternative approach to address the problem of the threephase four-wire shunt active power filter control methods.