Ayuda
Ir al contenido

Dialnet


Microstructural evolution during austempering of a ASTM A-532 CLASS III type high chromium white cast iron undergoing abrasive wear

  • Autores: Oscar Fabián Higuera Cobos, Jeison Bucurú Vasco, Andrés Felipe Loaiza Patiño, Mónica Monsalve, Dairo Hernán Mesa Grajales
  • Localización: Revista Facultad de Ingeniería, ISSN-e 2357-5328, ISSN 0121-1129, Vol. 26, Nº. 46, 2017, págs. 71-79
  • Idioma: inglés
  • Títulos paralelos:
    • Evolución microestrutural durante austemperado de una fundición blanca al alto cromo ASTM A-532, Clase III, Tipo A, sometida a desgaste abrasivo
  • Enlaces
  • Resumen
    • español

      Este trabajo estudia la influencia de variables tales como tiempo y temperatura de sostenimiento durante el austemperado de una fundición blanca al alto cromo con la siguiente composición: Cr, 25 %; C, 3 %; Si, 0.47 %; Mn, 0.74 %, y Mo, 1.02 %. El objetivo del austemperado fue modificar el porcentaje de austenita retenida, y correlacionarlo con la resistencia al desgaste abrasivo bajo diferentes condiciones; los ensayos fueron realizados según los lineamientos de la norma ASTM G65. Las técnicas de microdureza MEB-EDS y DRX fueron realizadas para determinar las propiedades mecánicas, composición química, tipo de carburos y microestructuras presentes, respectivamente. Los resultados mostraron que la mejor resistencia a la abrasión fue alcanzada a una temperatura de austemperado de 450 ºC y a 6 horas de permanencia.

    • English

      This paper studies the influence of variables such as holding temperatures and times during austempering of High Chromium White Cast Iron (HCWCI), with the following chemical composition: Cr 25 %, C 3 %, Si 0.47 %, Mn 0.74 % and Mo 1.02 %. The aim of the austempering was to modify the percentage of retained austenite and its correlation to abrasive wear resistance under different conditions.Microhardness tests, SEM-EDS and XRD were performed to determine mechanical properties, chemical composition, and type of carbides and microstructures present, respectively. The tests complied with the ASTM G-65 standard. Results showed that the best performance against abrasion was achieved for austempering at 450 ºC with holding time of 6 hours.


Fundación Dialnet

Dialnet Plus

  • Más información sobre Dialnet Plus

Opciones de compartir

Opciones de entorno