Machining With Cutting Tool Coated With Monolayer Of HfN

• Guzmán Durán, Pablo Andrés ^[1] ; Navarro-Devia, John Henry ^[1] ; Aperador Chaparro, Willian ^[1]
  1. [1] Universidad Militar Nueva Granada

     Universidad Militar Nueva Granada

     Colombia

     
• Localización: TECCIENCIA, ISSN-e 2422-3670, ISSN 1909-3667, Vol. 11, Nº. 21, 2016 (Ejemplar dedicado a: (JUL - DIC 2016)), págs. 1-6
• Idioma: español
• Enlaces
  • Texto completo (pdf)
• Resumen

  • In this study, AISI 1020 steel was machined by chip removal, in dry conditions, using ASSAB 17 tool bits with Hafnium Nitride (HfN) monolayer coating, deposited as a thin film via magnetron sputtering physical vapor deposition (PVD) technique, and uncoated tool bits, used as reference system. The surfaces of the machined steel were evaluated and characterized using Atomic Force Microscopy (AFM) and Scanning Electron Microscopy (SEM). The use of monolayer HfN coating on the tool bits was demonstrated to improve the surface finish of the workpiece and reduce cutting process time and cost