Ayuda
Ir al contenido

Dialnet


Resumen de Comparación de la resistencia al descementado del esmalte humano versus el esmalte vacuno con un sistema de autograbado

Rogelio José Scougall Vilchis, Lidia Gabriela Rios-Medina, Christian Yahaira Villarreal Camarena, Edith Lara-Carrillo, Alberto Salgado Valdés

  • español

    Objetivo. Comparar la resistencia al descementado que presenta el esmalte humano y el esmalte vacuno utilizando un sistema adhesivo de autograbado. Métodos. Un total de 25 incisivos vacunos y 25 molares humanos se almacenaron en timol al 0,2% (wt/vol) y se dividieron en dos grupos (n = 25/grupo). En ambos grupos el esmalte fue autograbado durante 5 s (Transbond Plus SEP) y se fabricaron aditamentos bite up con una plantilla de silicona y resina compuesta (Transbond Plus Color Change, 3M Unitek). Las muestras fueron fotopolimerizadas durante 10 s y almacenadas (37 °C, 24 h), y posteriormente se midió la resistencia al descementado (0,5 mm/min). Los resultados fueron estadísticamente analizados (t de Student), al igual que el índice de adhesivo remanente (ARI). Resultados. El valor promedio del grupo I (10,69 ± 5,46 MPa) fue significativamente inferior al del grupo II (17,55 ± 6,67 MPa). Respecto al ARI, no se encontraron diferencias significativas entre ambos grupos. Conclusiones. A pesar de que se ha reportado que la resistencia al descementado del esmalte vacuno es inferior a la obtenida con el esmalte humano, la presente investigación demostró que la morfología de la superficie de los molares humanos es tan diversa e irregular que impide tener una mayor adherencia a la resina compuesta cuando el esmalte es autograbado. (Rev Esp Ortod. 2013;43(2):074-078)

  • English

    Objective. To compare the bond strength between human and bovine enamel when using self-etching primer. Methods. A total of 25 bovine incisors and 25 human molars, were stored in Thymol solution 0.2% (wt/vol) and divided into two groups (n = 25/gr). In both groups the enamel was self-etched for 5 seconds (Transbond Plus SEP) and attachments bite up were fabricated with a silicone template and composite resin. The samples were light cured for 10 seconds, stored (37 °C, 24 h), and debonded (0.5 mm/min). The results were statistically analyzed (Student�s t). The remaining adhesive (ARI) index was also analyzed. Results. The average value of group I 10.69 ± 5.46 MPa was significantly lower than group II 17.55 ± 6.67 MPa. Comparable scores of ARI were found between groups. Conclusions. Although it has been reported that the bond strength of bovine enamel is lower than that obtained with human enamel; the results of this research showed that the diversity on the morphological surface of human molar produce lower shear bond strength than the flat surface of bovine teeth when the enamel is self-etched. (Rev Esp Ortod. 2013;43(2):074-078)


Fundación Dialnet

Dialnet Plus

  • Más información sobre Dialnet Plus