Bonding behavior "Eucalyptus benthamii" wood to manufacture edge glued panels

• Autores: Sabrina A. Martins, Cláudio H. S. del Menezzi, Joana M. Ferraz, Mário R. de Souza
• Localización: Maderas: Ciencia y tecnología, ISSN 0717-3644, ISSN-e 0718-221X, Vol. 15, Nº. 1, 2013, págs. 79-92
• Idioma: inglés
• Enlaces
  • Texto completo (pdf)
  • Texto completo (pdf)
• Resumen

  • The main objective of this study was to evaluate the performance of Eucalyptus benthamii Maiden et Cambage wood for the production of edge glued panels. Wood pieces with planed and sanded surfaces were bonded using cross-linking polyvinyl acetate (PVAc) and polyurethane (PUR) based adhesives, at pressures of 0.7 MPa and 1.0 MPa. The same adhesives were used for finger jointing at a pressure of 1.5 MPa. The bonding strength was determined through glue-line shear strength and bending test for finger jointing. According to the results, the pressure and surface preparation variables did not influence the glue-line shear strength of the adhesive PVAc, whereas for the PUR adhesive strength was influenced by the pressures and machining used. All treatments met the minimum values required by the standard; however, the highest bonding strength was found in the sample glued with PUR adhesive at a pressure of 1.0 MPa and sanded surface. The highest modulus of rupture was obtained in the samples glued using PVAc, while the modulus of elasticity was not affected by the type of adhesive used. These results enabled concluding that with regard to its technological properties assessed in the present study, E. benthamii wood is suitable for the production of edge glued panel.