Applicability of the finite element method to analyze the stresses produced in concrete slabs over ground by tire loads of agricultural tractors

• Autores: Hugo Malón Litago, Francisco Javier García Ramos, P. Hernández, M. Vidal, Antonio Boné Garasa
• Localización: Spanish journal of agricultural research, ISSN-e 2171-9292, ISSN 1695-971X, Vol. 11, Nº. 1, 2013, págs. 47-55
• Idioma: inglés
• Enlaces
  • Texto completo (pdf)
• Resumen

  • There are several methods to dimension concrete slabs due to vehicle loads, most of them based on Westergaard theory. These methods have been developed for industrial vehicles (cars, trucks and forklifts). Considering agricultural buildings one of the most used vehicles is the agricultural tractor whose characteristics (tires of great dimensions but with a reduced contact surface) are different to those of the industrial vehicles. The goal of this research was to analyze the applicability of the finite element method (FEM) to estimate the stresses generated on the concrete slabs considering the loads transmitted by agricultural tractors. To achieve this objective, the effect of the loads transmitted by the rear axle tires of three agricultural tractors has been considered. In parallel, the same study has been carried out using the Westergaard theory. As a preliminary step, to validate the FEM, a numerical analysis has been made to obtain the stresses generated on a concrete slab considering three forklifts. The numerical analysis results have been compared with those obtained by mean of validated methods (Portland Cement Association) and the classical theory of Westergaard. For each agricultural tractor, the actual geometry of the contact surface of tires has been measured on a concrete slab and discretized by the FEM. As a result of the research process developed, it is possible to conclude that the FEM is a valid tool to analyze the tensions generated by the loads transmitted by the tires of agricultural tractors on concrete floors supported on the ground.