F. Equihua, A. Salinas, E. Nava
El objetivo del presente trabajo es investigar el efecto del contenido de aluminio y silicio sobre la temperatura critica de transformacion, durante el enfriamiento, en aceros electricos de grano no-orientado (GNO) de bajo carbono laminados en caliente. Dos muestras, con diferentes contenidos de aluminio: A=0,22 y B=0,61 % en peso, fueron analizadas mediante la tecnica in-situ de difraccion de rayos X a alta temperatura. Las muestras fueron austenizadas a 1.050 ��C durante 5 min y, subsecuentemente, enfriadas de manera escalonada cada .10 ��C dentro de la camara de alta temperatura instalada en un difractometro Philips X�fpert. Los patrones de difraccion fueron registrados cada .10 ��C durante el enfriamiento desde 1.000 hasta 720 ��C. La temperatura de transformacion austenita . ferrita, Ar3, fue estimada a partir de los cambios en la intensidad de los picos (110)-�¿ y (111)-�Á en funcion de la temperatura.
Los resultados de dichos experimentos mostraron que la temperatura de transformacion, Ar3, aumenta con el incremento del contenido de aluminio, desde 0,22 a 0,61 % en peso. Adicionalmente, el rango bifasico (austenita + ferrita) en el sistema Fe-C disminuye con el incremento de aluminio y silicio en los aceros experimentales. Los resultados de difraccion de rayos X fueron sustentados por observaciones microestructurales en muestras del acero B, el cual fue sometido tratamientos termicos similares a los empleados en los experimentos de DR-X. Se observaron finas capas de ferrita a temperaturas cercanas a la temperatura Ar3 obtenida experimentalmente en el acero B.
The aim of the present study is to investigate the synergistic effect of silicon and aluminum content on the austeniteferrite transformation temperatures on cooling (Ar3, Ar1) in non-oriented (GNO) Al-Si-low carbon electrical steel strips. Two specimens with different Al contents: A=0.22 wt% and B=0.61 wt%Al, were analyzed by ¿in-situ¿ high temperature X-ray diffraction experiments. The samples were austenitized at 1050 °C for 5 minutes and sequentially cooling in a stepwise manner by steps of 10 °C inside an environmental chamber installed in a Philips X¿Pert multi-purpose diffractometer. X-ray diffraction patterns were recorded every 10 °C during cooling from 1000 to 720 °C. The austenite to ferrite transformation temperatures on cooling, Ar3 and Ar1, were estimated from changes in the intensities of the (110)-á and (111)-ã peaks as a function of temperature. The results of the experiments show that the transformation temperatures increase with increasing aluminum content from 0.22 to 0.61 wt%. In addition, the two-phase field (austenite + ferrite in the system Fe-C decreases with increasing silicon and aluminum contents for these GNO steels. X-Ray diffraction results were supported by microstructural observations of quenched samples of steel B which were subjected to similar heat treatment conditions than those applied in the X-ray diffractometer experiments. Thin ferrite films (~ 4-10 ìm) were observed in the microstructure of specimens of steel B quenched from temperatures close to the experimental Ar3.
© 2001-2024 Fundación Dialnet · Todos los derechos reservados