Alain Ariel de la Rosa Andino, Patricio Rubén Alcocer Quinteros, Omar González Cueto, Alberto Masaguer, Miguel Herrera Suárez
El presente trabajo se realizó con el objetivo de ajustar los parámetros constitutivos del modelo de Drucker-Prager Extendido (DPE) que definen la fase de deformación plástica del suelo en la simulación de la respuesta mecánica de un suelo de textura arcillosa (Vertisol). La curva esfuerzo-deformación se dividió en dos partes y se buscaron dos ecuaciones que describen su trayectoria. Los datos iniciales se correspondieron con los datos determinados experimentalmente. A partir de estos se buscarán los valores aproximados tanto del ángulo de fricción interna del plano de falla del modelo de Drucker-Prager Extendido, así como, el ángulo de dilatancia. Finalmente se estimaron los valores óptimos de estos ángulos, disminuyendo los errores en las predicciones del modelo DPE por debajo del 4,35% haciéndolo adecuado para la simulación de la respuesta mecánica del suelo investigado
This research work was carried out with the aim of adjusting the constitutive parameters of the Extended Drucker-Prager (EDP) model which defines the phase of plastic deformation of soil in the simulation of the mechanical response of clayey soil (Vertisol). The stress-strain curve is divided into two parts and two equations describing its path were obtained. Initial data were consistent with the experimentally determined data. Starting from these results, the approximate values of both the internal friction angle of the fault plane of the Extended Drucker-Prager model, as well as the angle of dilatancy were searched out. Finally the optimum values of these angles were estimated, reducing errors in the predictions of the EDP model below 4.35% and turning this model adequate for simulating the mechanical response of the soil object of investigation
© 2001-2025 Fundación Dialnet · Todos los derechos reservados