Proceeding of the institute of mechanical engineers . Part B. Journal of engineering manufacture

• 

  Año 2003, Vol. 217, Número 9

  • Technology roadmapping¿developing a practical approach for linking resources to strategic goals

    D. R. Probert, R. Phaal, C. J. P. Farrukh

    págs. 1183-1195

    

  • Enhanced product functionality with life cycle units

    A. Buchholz, G. Seliger, U. Kross

    págs. 1197-1202

    

  • Assessing the manufacturability of early product designs using aggregate process models

    P. G. Maropoulos, D. G. Bramall, K. R. McKay

    págs. 1203-1214

    

  • Decision making in conceptual engineering design: an empirical investigation

    A. C. Elliott, N. D. Burns, M. Girod, I. C. Wright

    págs. 1215-1228

    

  • Managing product development resources through the use of product quality attribute mapping

    I. C. Wright, A. C. Elliott, Ed Swain

    págs. 1229-1241

    

  • Flatness adaptive control of a hot strip in finishing mills

    W. K. Hong, J. J. Choi, J. S. Kim, J. J. Yi

    págs. 1243-1252

    

  • Determination of the formability of stainless steel sheets using the technological proofing method

    S. E. Silveria Netto, L. Schaeffer, R. Hennig, R. S. Crivellaro, N. V. Malveira, C. A. Borsoi

    págs. 1253-1257

    

  • Optimum control of process parameters in electrical upsetting

    Y. Sun, T. Liu, T. Zhang, Z. Zhang, T. Luo

    págs. 1259-1263

    

  • Thixoforming process of a component with a non-circular type of metal matrix composite and its formability limitation

    C. G. Kang, Y. P. Jeon

    págs. 1265-1277

    

  • Detection of causes of casting defects assisted by artificial neural networks

    M. Perzyk, A. Kochanski

    págs. 1279-1284

    

  • Computer-integrated optics design and tool path generation in virtual machining of aspheric surfaces

    J. G. Li, C. F. Cheung, W. B. Lee

    págs. 1285-1294

    

  • Tool life and tool wear during high-speed rough milling using alternative cutter path strategies

    C. K. Toh

    págs. 1295-1304

    

  • A study of a dual-electromagnetic sensor system for weld seam tracking of I-butt joints

    J. W. Kim, J. H. Shin

    págs. 1305-1313

    

  • An application of computer vision for programming computer numerical control machines

    I. M. Elewa, E. S. Gadelmawla, A. A. Abdel-Shafy, A. E. Eladawi

    págs. 1315-1324

    

  • Drilling and deburring in a single process

    D. A. Dornfeld, K. Lee, K. H. Kim, S. Y. Jeon, C. H. Cho

    págs. 1327-1331

    

  • Development of a machining simulator considering machine behaviour

    A. Dugas, J. J. Lee, J. Y. Hascoët, M. Terrier

    págs. 1333-1339