IEE Proceedings: Electric power applications

• 

  Año 2005, Vol. 152, Número 4

  • Time and frequency domain analysis of a falut-tolerant space vector PWM VSI-fed induction motor drive

    J. Klima

    págs. 765-774

    

  • Practical EMI-filter-design procedure for high-power high-frequency SMPS according to MIL-STD 461

    I. Cadirci

    págs. 775-782

    

  • Modulating functions for modelling PWM switching converters

    A. Landi, L. Sani

    págs. 783-792

    

  • High-efficiency DC/DC converter with high voltage gain

    R. J. Wai, R. Y. Duan

    págs. 793-802

    

  • Dynamic simulation of cage induction machine with air gap eccentricity

    G. M. Joksimovic

    págs. 803-811

    

  • Equivalent circuit modelling of new brushless synchronous alternator

    N. L. Brown, L. Haydock, A. Novinschi, E. Spooner, A. Mebarki

    págs. 812-820

    

  • Analysis and design of power gyrators in sliding-mode operation

    Luis Martínez Salamero, Angel Cid Pastor

    págs. 821-826

    

  • Cascade controller for DC/DC buck converter

    W. L. Chan, K. M. Tsang

    págs. 827-831

    

  • Thermal analysis of high-frequency transformers using finite elements coupled with temperature rise method

    C. C. Hwang, P.-H. Tang, Y. H. Jiang

    págs. 832-836

    

  • Formulation of the energy-storage factor for isolated power convertors using integrated magnetics

    K. W. E. Cheng

    págs. 837-844

    

  • Dead-time compensation strategy for permanent magnet synchronous motor drive taking zero-current clamp and parasitic capacitor effects into account

    N. Urasaki, T. Senjyu

    págs. 845-854

    

  • Comparison of two techniques for two-dimensional finite-element inductance computation of electrical machines

    E. Campero-Littlewood, R. Escarela Perez

    págs. 855-861

    

  • Modelling and prediction of iron loss with complex flux waveforms

    J. T. Charton

    págs. 862-870

    

  • Small-signal model-based design of digital current-mode control

    Y. S. Jung

    págs. 871-877

    

  • Analysis of a capacitive-filter, half-wave rectifier fed by a parallel-load resonant tank

    M. P. Theodoridis

    págs. 878-884

    

  • Safety assessment of AC eathing systems in a DC traction-supply substation

    S.-D. Lin, C.-H. Lee

    págs. 885-893

    

  • Dynamic field modelling of torque and radial forces in vector-controlled induction machines with bearing relief

    U. A. U. Amirulddin

    págs. 894-904

    

  • Front-end low-frequency switched-mode rectifier and its control for permanent-magnet synchronous-motor drive

    J. W. Chen, J. L. Chen, H. C. Chen, Y. C. Chang

    págs. 905-914

    

  • High-performance flux-based two-degrees-of-freedom uninterruptible power supply

    G. H. H. Pang, P. C. Loh

    págs. 915-921

    

  • Development and analysis of a novel soft-starter/energy-saver topology for delta-connected induction motors

    K. Sundareswaran

    págs. 922-932

    

  • Equivalent circuit for the brushless doubly fed machine (BDFM) including parameter estimation and experimental verification

    R. A. McMahon, P. C. Roberts

    págs. 933-942

    

  • Analysis of a high-power-factor AC-DC converter with reduced current and voltage stresses

    D. D.-C. Lu, D. K.-W. Cheng

    págs. 943-952

    

  • Variable-structure observer for solar-array current estimation in a photovoltaic power-generation system

    I.-S. Kim, M. J. Youn

    págs. 953-959

    

  • Harmonic adjusted power factor correction in nonsinusoidal environment

    A. F. Zobaa

    págs. 960-966

    

  • Line-start performance of single-phase synchronous reluctance motor with controlled capacitor

    E. S. Obe

    págs. 967-976

    

  • Modelling and controller design of inductor-coupled multimodule DC-DC convertor with master-slave current-comparing scheme

    R.-T. Chen, Y.-Y. Chen

    págs. 977-989

    

  • Airgap fringing flux reduction in inductors using open-circuit copper screens

    B. Williams, J. Fletcher

    págs. 990-996

    

  • Initial pole-position estimation of linear motor

    W.-E. Yun, J.-W. Choi, H.-G. Kim

    págs. 997-1002

    

  • Probabilistic load flow in AC electrified railways

    Y. L. Chi, T. K. Ho

    págs. 1003-1014

    

  • Supervisory enhanced genetic algorithm controller design and its application to decoupling induction motor drive

    K.-H. Su, C.-C. Kung

    págs. 1015-1026