Estudio e implementación de algoritmos de fusión sensorial para sensores pulsantes y clásicos con protocolo AER de comunicación y aplicación en sistemas robóticos neuroinspirados
Identificadores
Statistics
Share
Metadata
Show full item recordAuthor/s
Pérez Peña, FernandoDate
2014-10-10Department
Ingeniería en Automática, Electrónica, Arquitectura y Redes de ComputadoresAbstract
The objective of this thesis is to analyze, design, simulate and implement a model that follows the principles of the human nervous system when a reaching movement is made.
The background of the thesis is the neuromorphic engineering field. This term was first coined in the late eighties by Caver Mead. Its main objective is to develop hardware devices, based on the neuron as the basic unit, to develop a range of tasks such as: decision making, image processing, learning, etc.
During the last twenty years, this field of research has gathered a large number of researchers around the world. Spike-based sensors and devices that perform spike processing tasks have been developed.
A neuro-inspired controller model based on the classic algorithms VITE and FLETE is proposed in this thesis (specifically, the two algorithms presented are: the VITE model which generates a non-planned trajectory and the FLETE model to generate the forces needed to hold a position reached). The hardware platforms used to implement them are a FPGA and a VLSI multi-chip setup. Then, considering how a reaching movement is performed by humans, these algorithms are translated under the constraints of each hardware device. The constraints are: spike-processing blocks described in VHDL for the FPGA and neurons LIF for the VLSI chips. To reach a successful translation of VITE algorithm under the constraints of the FPGA, a new spike-processing block is designed, simulated and implemented: GO Block.
On the other hand, to perform an accurate translation of the VITE algorithm under VLSI requirements, the recent biological advances are studied. Then, a model which implements the co-activation of NMDA channels (this activity is related to the activity detected in the basal ganglia short time before a movement is made) is modeled, simulated and implemented.
Once the model is defined for both platforms, it is simulated using the Matlab Simulink environment for FPGA and Brian simulator for VLSI chips.
The hardware results of the algorithms translated are presented. The open-loop spike-based VITE (on both platforms) and closed-loop (FPGA) applied and connected to a robotic platform using the AER bus show an excellent behaviour in terms of power and resources consumption. They show also an accurate and precise functioning for reaching and tracking movements when the target is supplied by an AER retina or jAER. Thus, a full neuro-inspired architecture is implemented: from the sensor (retina) to the end effector (robot) going through the neuro-inspired controller designed.
An alternative for the SVITE platform is also presented. A random element is added to the neuron model to include variability in the neural response. The results obtained for this variant, show a similar behaviour if a comparison with the deterministic algorithms is made. The possibility to include this pseudo-random controller in noise and / or random environment is demonstrated.
Finally, this thesis claims that PFM is the most suitable modulation to drive motors in a neuromorphic hardware environment. It allows supplying the events directly to the motors. Furthermore, it is achieved that the system is not affected by spurious or noisy events.
The novel results achieved with the VLSI multi-chip setup, this is the first attempt to control a robotic platform using sub-thresold low-power neurons, intended to set the basis for designing neuro-inspired controllers.
Subjects
VITE; FPGA; SNN; FLETE; motor controlCollections
- Tesis [592]
- Tesis Ing. Sis. Aut. [9]