Ayuda
Ir al contenido

Dialnet


Modelización gravimétrica de la Isla de Mallorca

  • C. Ayala [1] ; J. Pous [1] ; F. Sàbat [1] ; A. Casas [1] ; L. Rivero [1] ; B. Gelabert [2]
    1. [1] Universitat de Barcelona

      Universitat de Barcelona

      Barcelona, España

    2. [2] Universitat de les Illes Balears

      Universitat de les Illes Balears

      Palma de Mallorca, España

  • Localización: Revista de la Sociedad Geológica de España, ISSN 0214-2708, Vol. 7, Nº. 3-4, 1994, págs. 215-227
  • Idioma: español
  • Enlaces
  • Resumen
    • español

      Se ha elaborado un nuevo mapa de anomalías de Bouguer. La anomalía regional se ha obtenido mediante ajuste polinómico, imponiendo como ligadura la modelización de dos pe1files sísmicos profundos que atraviesan Mallorca. Sustrayendo la anomalía regional a la anomalía de Bouguer se ha obtenido la residual. Los mínimos absolutos y relativos de los mapas de Bouguer y residual coinciden con las cuencas cenozoicas, y los máximos coinciden con sierras donde afloran rocas mesozoicas. La anomalía residual se ha modelizado en tres perfiles que atraviesan Mallorca de NW a SE. Para ello ha sido necesario estimar la densidad de las distintas rocas del subsuelo. Para cada perfil se han realizado dos modelos con resultados similares. En ellos se considera que los mínimos son debidos a los sedimentos poco densos que rellenan las cubetas y que los máximos están asociados al relieve del techo del paleozoico. El espesor obtenido para los sedimentos de la cubeta de Inca es de 1600 m. Este espesor es excesivo para corresponder únicamente a sedimentos postorogénicos y se sugiere que la cubeta se inició durante la compresión aligo-miocena. Por otra parte, los peldaños del techo del Paleozoico son superiores a 2000 m, que es más del doble de lo que podría explicarse mediante las fallas normales que delimitan las cuencas. Se sugiere que los cabalgamientos oligomiocenos han contribuido de forma fundamental a la creación de estos peldaños.

    • English

      A Bouguer anomaly map of Mallorca Island was obtained recalculating the corrections of 3623 points measured by ITGE. 220 new stations were added. We have modeled the anomaly produced by the crust deduced from two deep seismic profiles crossing Mallorca. The regional anomaly has been obtained by polinomic adjustment constrained by the anomaly resulting from the two seismic profiles. Constraints are imposed by the Lagrange multipliers methode. The residual anomaly is obtained by substraction of the regional anomaly from the Bouguer anomaly. The absolute and relative lows depicted on the Bouguer and residual anomaly maps correspond exactly with Cenozoic basins, and highs on these maps correspond with areas where Mesozoic rocks outcrop. Three NW-SE cross sections has been modeled in order to explain the residual anomaly. The density of subsurface rocks involved in these sections have been estimated from measurements on outcroping rocks and borehole cores. Two different models are proposed for each cross section which yield similar results. In these models the gravity lows are explained by the sedimentary infill into the basins, and the gravity highs by elevations in the top of Paleozoic. The difference between observed and modeled anomaly is less than 1 mGal except for the ends of the sections where a border effect is present. The thickness of Cenozoic sediments in the Inca basin is more than 1600 m. This value is too high to correspond only to postorogenic sediments; thus, it is suggested that this basin initiated during Oligo-Miocene compression. Moreover, the steps in the top of the Paleozoic are higher than 2000 m. Less than half of this relieve can be explained by normal faults associated with the basin formation, and it is suggested that Paleozoic rocks are involved in the Oligo-miocene basal thrust.


Fundación Dialnet

Dialnet Plus

  • Más información sobre Dialnet Plus

Opciones de compartir

Opciones de entorno