Evren Gul, V. Roshan Joseph, Huan Yan, Shreyes N. Melkete
Understanding the uncertainty in simulation outputs is important for careful decision-making regarding a machining process. However, Monte Carlo–based methods cannot be used for evaluating the uncertainty when the simulations are computationally expensive. An alternative approach is to build an easy-to-evaluate emulator to approximate the computer model and run the Monte Carlo simulations on the emulator. Although this approach is very promising, it becomes inefficient when the computer model is highly nonlinear and the region of interest is large. Most machining simulations are of this kind because the output is affected by several quantitative factors—such as the workpiece material properties, cutting tool parameters, and process parameters whose effects can change depending on other qualitative factors such as the type of materials, tool designs, and tool paths. Because the number of levels of the qualitative factors can range from tens to thousands, building an accurate emulator is not an easy task. This article proposes a new approach, called an in situ emulator, to overcome this problem. The idea is to build an emulator for the user-specified levels of the qualitative factors and inside the local region defined by the input uncertainty distribution of the quantitative factors. Efficient experimental design and statistical modeling techniques are used for constructing the in situ emulator. The approach is illustrated using the simulations of two solid end milling processes.
© 2001-2024 Fundación Dialnet · Todos los derechos reservados